What's on your work bench?

[NippleWrestler]

New wiring for this guy courtesy of a kit from Tone shapers. CTS pots, switchcraft jack and switch (not used), orange drops (if you care), and treble bleeds. It even comes with a choice of braided wire or shielded 4 wire.



Good stuff and $80 for the kit (shipped off Amazon au) is a good rate for name brand parts

[Bg]

Sounds a good deal

[ChAoZ]

Just got this one finished, Honduran Mahogany body with a lightly figured Blackbean top, 6 piece Wenge neck with Indian Rosewood fretboard, jumbo stainless steel frets Gotoh truss rod, bridge and tuners, Seymour Duncan - Slash pickup set, black pearloid binding on body and neck including headstock, strung with a set of D'Addario 10's, sounds and plays as good as it looks \m/ > < \m/

289396443_4882568598514319_7244798721690881583_n.jpg (66.23 KiB) Viewed 525 times

289157276_4882568518514327_432763413909226724_n.jpg (47.83 KiB) Viewed 525 times

[jeremyb]

Printed out a custom humbucker template for my strat, just waiting on a top bearing flush trim router bit to arrive

[MikeC]

Printed out a custom humbucker template for my strat, just waiting on a top bearing flush trim router bit to arrive

Got a pic?

[jeremyb]

Printed out a custom humbucker template for my strat, just waiting on a top bearing flush trim router bit to arrive

Got a pic?

This is the first prototype, making some changes more to suit the router bit I’m going till be using, rounded corners etc…

[MikeC]

Awesome. What's it cost to 3D print an object like this?

[jeremyb]

Awesome. What's it cost to 3D print an object like this?

Maybe a dollar worth of plastic? Plus my labour for the 4 minutes it took to knock up the 3d model