Through this together over the last few days:
First time doing all the case work and messed it up a little. Going to get another case and transplant it all.
MXR Noise Gate clone
Moderators: Slowy, Capt. Black
-
- Vintage Post Junkie
- Posts: 1358
- meble-kuchenne.warszawa.pl
- Joined: Fri Apr 27, 2018 3:14 pm
- Location: Wellywood
- Has liked: 18 times
- Been liked: 265 times
- chur
- Vintage Post Junkie
- Posts: 1268
- Joined: Sun Aug 02, 2009 4:05 pm
- Location: Christchurch
- Has liked: 169 times
- Been liked: 210 times
Re: MXR Noise Gate clone
Drilling the cases is my least fav job tbh; well that and labeling. Always fearful of mucking it up and only ever buy enough cases for the job I'm working on, so measure about 3 times before committing.Candeevr4 wrote: First time doing all the case work and messed it up a little. Going to get another case and transplant it all.
No one ever died of hard work.. but why take the risk..
- NippleWrestler
- Vintage Post Junkie
- Posts: 2921
- Joined: Sat Jan 02, 2016 5:05 pm
- Has liked: 79 times
- Been liked: 1072 times
Re: MXR Noise Gate clone
It's a bummer that tayda don't sell enclosures with placements for less than 3 controls.
-
- Vintage Post Junkie
- Posts: 1358
- Joined: Fri Apr 27, 2018 3:14 pm
- Location: Wellywood
- Has liked: 18 times
- Been liked: 265 times
Re: MXR Noise Gate clone
I used the pedalpcb drilling template, but i used it three times rather than once... learning curve.chur wrote:Drilling the cases is my least fav job tbh; well that and labeling. Always fearful of mucking it up and only ever buy enough cases for the job I'm working on, so measure about 3 times before committing.
-
- Vintage Post Junkie
- Posts: 1358
- Joined: Fri Apr 27, 2018 3:14 pm
- Location: Wellywood
- Has liked: 18 times
- Been liked: 265 times
Re: MXR Noise Gate clone
With the job my builder did with some of my windows, its not just your roofers......Olderama wrote:off center is the new center
just ask my roofers..........
- Snarblinge
- Ashton
- Posts: 274
- Joined: Mon Apr 27, 2009 7:39 pm
- Has liked: 34 times
- Been liked: 43 times
Re: MXR Noise Gate clone
3 in a row is the hardest, use a punch ( or a screw as I did for years) to mark out, then drill guide holes. I have bought a bunch of 3mm bits for guide holes, work best if sharp. i'd leave that one in that enclosure, surely the noise gate belongs on a toggle in a multi fx of your own creation.
b.