Page 10 of 10
Re: Pedal Building Resources
Posted: Fri Jan 14, 2022 6:52 pm
by FuzzMonkey
chur wrote: ↑Thu Jan 13, 2022 10:56 am
I have done it using solder wick and it wasn't too bad. I usually have a few spare boards, so probably wouldn't bother most of the time unless desperate.
Funny you mention the ribbon, I'm up to about the 12th build now over the last few years, and each time I say the same thing... and then never buy any
Fair enough. For US$1 from PedalPCB, it is hard to complain. I assume they are the fairly standard ground the input to the effect in bypass mode style of true bypass? I never actually checked.
Re: Pedal Building Resources
Posted: Tue Apr 04, 2023 11:02 am
by jeremyb
3D printed drilling guides!
https://www.keechdesign.com/
I should design some, looks like good money to be made
Re: Pedal Building Resources
Posted: Tue Apr 04, 2023 7:31 pm
by FuzzMonkey
You should. You could called them 'JB's Jigs'.
Re: Pedal Building Resources
Posted: Tue Apr 04, 2023 11:08 pm
by jeremyb
FuzzMonkey wrote: ↑Tue Apr 04, 2023 7:31 pm
You should. You could called them 'JB's Jigs'.
Like Pauline’s pens, only available at a local shop for local people!!!
Re: Pedal Building Resources
Posted: Sat Feb 03, 2024 1:18 pm
by TmcB
Got a new soldering iron recommendation- Ksger T12
https://a.aliexpress.com/_mLB7286
Heats in 2 seconds, is tiny and cheap.
Tony Pepers recommended it, arrived in 6 days, and it’s superb.
$70ish can’t be beat.
Re: Pedal Building Resources
Posted: Sat Feb 03, 2024 8:53 pm
by FuzzMonkey
TmcB wrote: ↑Sat Feb 03, 2024 1:18 pm
Got a new soldering iron recommendation- Ksger T12
https://a.aliexpress.com/_mLB7286
Heats in 2 seconds, is tiny and cheap.
Tony Pepers recommended it, arrived in 6 days, and it’s superb.
$70ish can’t be beat.
I was looking at something similar before being gifted a Goot RX711AS soldering station.