I’ve got a Mr Glyn Pandora bridge pickup on the way which has 3 taps for different outputs.
It’s going to replace the Cruel Mistress which is currently in my Tele as it apparently has the Cruel Mistress as one of its taps anyway.
I’m either going to put a push pull pot in to get 2 different sounds off the pickup or a Strat 5 way Super switch to get all 3 sounds.
There’s not much info on how to wire up a super switch online, can anyone offer a diagram on wiring a Tele with 2 pickups but with 3 different wires on the bridge pickup?
Superswitch wiring help.
Moderators: Slowy, Capt. Black
- Reg18
- Vintage Post Junkie
- Posts: 3759
- meble-kuchenne.warszawa.pl
- Joined: Thu Feb 06, 2014 1:57 pm
- Has liked: 335 times
- Been liked: 981 times
-
- Chorus of Organs
- Posts: 42475
- Joined: Sat Dec 06, 2008 9:03 am
- Has liked: 8085 times
- Been liked: 4309 times
Re: Superswitch wiring help.
The best info perhaps is from the stewmac site: https://www.stewmac.com/video-and-ideas ... nd-wiring/
However what about using a 3 way blade with each position for one of the taps and then a push-pull to bring the neck pickup into the circuit?
You would just use one side of the 3 way, one pin is the common and the other 3 are your 3 positions.
However what about using a 3 way blade with each position for one of the taps and then a push-pull to bring the neck pickup into the circuit?
You would just use one side of the 3 way, one pin is the common and the other 3 are your 3 positions.
- Cdog
- Vintage Post Junkie
- Posts: 4443
- Joined: Wed Feb 07, 2007 3:01 pm
- Location: Christchurch
- Has liked: 3642 times
- Been liked: 741 times