NAD - Custom Fender DR

[Marshmallow]

Fender DR Type
6v6x2 18w
One tube reverb
GZ34 Rectified
Choke
Master Volume
Presence
Mid Boost Knob
FX Loop
Bias pins

Instagram:
https://www.instagram.com/thomasargil/?hl=en

Currently one of my Fav amps.









Link to build
https://www.nzguitars.com/forum/viewtop ... 41&t=40078

[MiniForklift]

Wow. Beautiful! Well done, bet that sounds incredible

[Marshmallow]

Wow. Beautiful! Well done, bet that sounds incredible

Thanks man!

[codedog]

Wow, with master volume! Would love to hear how this sounds.

[robthemac]

Dibs.

[MikeC]

Looks so professional, well done (again). How do you make the lettering?

[Marshmallow]

Dibs.

Quick haha

[Marshmallow]

Looks so professional, well done (again). How do you make the lettering?

Hi Mike, Thanks. I was gonna get someone to cut the vinyl so I can paint the letterings myself , like silkscreen but the cheap version.. However this time, I applied a printed vinyl on a 1mm thick faceplate. It was way easier. Currently the only amp with a faceplate due to the other ones being a little too big which I may have to actually use the cut vinyl application.

[robthemac]

Dibs.

Quick haha

Serious.

[MikeC]

Looks so professional, well done (again). How do you make the lettering?

Hi Mike, Thanks. I was gonna get someone to cut the vinyl so I can paint the letterings myself , like silkscreen but the cheap version.. However this time, I applied a printed vinyl on a 1mm thick faceplate. It was way easier. Currently the only amp with a faceplate due to the other ones being a little too big which I may have to actually use the cut vinyl application.

So do you print the vinyl with your own printer? If not, how do you do it (unless it's a trade secret)? Cheers.

[Bg]

nzemblems will do you vinyl printing, works out really well too....

[Marshmallow]

Looks so professional, well done (again). How do you make the lettering?

Hi Mike, Thanks. I was gonna get someone to cut the vinyl so I can paint the letterings myself , like silkscreen but the cheap version.. However this time, I applied a printed vinyl on a 1mm thick faceplate. It was way easier. Currently the only amp with a faceplate due to the other ones being a little too big which I may have to actually use the cut vinyl application.

So do you print the vinyl with your own printer? If not, how do you do it (unless it's a trade secret)? Cheers.

Yea one of my mates have one if those $1000 printer haha no trade secret haha