NZGuitars.com : Filling you with GAS since 2003

jeremyb wrote: ↑Wed Dec 27, 2023 12:22 pm https://www.offsetguitars.com/forums/vi ... p?t=107363

Mate, that is a pre covid report

I am with Chaoz, for that money I make my own

And like Novo I have four letters too in my logo

Bg wrote: ↑Fri Dec 22, 2023 7:34 pm My workbench on my workbench, half lap joint 5

That deserves to be put together with hide glue and tapered dowels. Then nitro for finish

There is a lot to take in...

Look closely

He looks skinny there

perhaps?
https://www.thegearpage.net/board/index ... m.1898173/

I’ve got a neck pocket that is 1.5mm too small, and needs an angled cut. I could slowly sand it, but am not sure I’ll get it perfect. Is the pocket too small or the neck too big? Which one is the more expensive, neck or body? Has the body been finished? All neck pockets have an 'angled cut' as the ...

There is this bad boy close by https://www.trademe.co.nz/a/marketplace/building-renovation/tools/power-tools/drills-screwdrivers/listing/4462328575 Can't see the brand on this one. If it were an old Tanner or Dyco it might be worth restoring. Observations: Shaft corroded, needs work to make the tab...

Kerry @ Chaoz guitars could also no doubt do it, it's just routing a neck pocket. Pretty basic stuff for a regular fender style (no neck angle). Thanks Terry, now that's a recommendation - although not sure if it was supposed to only sound like I could do it because it was easy :crybaby: I'm not in...

It'll be fine assuming voltage rating of caps is suitable. I think they’re all 450v Thanks, sorry was probably a silly question No, it was a perfectly valid question. I just didn't want to provide a diagnosis without knowing all the facts :geek: You should go into politics, facts are religion there...

StrummersOfThunder wrote: ↑Thu Dec 07, 2023 6:53 pm But that aside, in essence, should it matter ?

No

MikeC wrote: ↑Thu Dec 07, 2023 7:33 pmTube rectifier?

The schematic is visible on thd 3rd photo on page 1 of this thread.

It uses diodes.

I found there were two 'types'... the shitty ones with a slightly shorter thread shaft and crappy thread, ie Jaycar. The good ones with a good thread and the shaft just that little bit longer. The latter from Amplified parts

I had mine printed straight on the chassis once but it only just fitted in the printer so to speak. I don't recommend it, buy some jacks with longer shaft and more thread

Visited Japan a few weeks back and had to bring back a souvenir. Eventually decided to spend much more than initially planned by getting something super cool (in my opinion) rather than just another guitar Found that ishibashi online prices are 20% above what you can get in store if you take your p...