Fair exchange ain't no robbery

Moderator: Capt. Black

#821313
Would be keen to trade for a Creamback H or M.

As for Mesa V30 vs. “standard” V30, yes there is a difference. Celestion UK make the Mesa V30 to boogie specs, mostly the same sound but with a smidge less top end sizzle......apparently. Sounds like a v30 to me! Lol
#821326
Not quite, the mesa v30 is the original design of the v30 which has gone through different iterations yet mesa basically made a big enough order to have theirs made to the original spec. Here's what Steve fryette had to say on the matter:

"The 30 in V30 has nothing to do with power handling. But making a distinction between the Mesa version and the off-the-shelf version is legit, even though it has little to do with actual power handling capacity. The rated power handling of the V30 of any version (see below) is 65W.

The Mesa version is OEM. This is the T4416 model, which is an 16 ohm speaker. It is made in England specifically for Mesa. But Mesa didn't specify it that way. From what we were told by Celestion around 1997-8, Celestion changed the model T3904 (16 ohm) V30 design in the early 90s to make it easier and cheaper to produce. Mesa didn't like it and insisted on the original version, which then became an OEM model. The 8 ohm version of the Mesa speaker is the T4335. To get an OEM model from Celestion requires a large order. This speaker was made on a separate production line from the off-the-shelf V30, which as Van Nord says is fizzy and thin sounding by comparison.

There is a third 16 ohm version only used by Marshall - T3897 - which is even brighter.

When we were using Celestion speakers, we found out about the existence of the T4416 which we had purchased from our German distributor at the time and asked Celestion about it. They had claimed that they didn't offer OEM varitions of the V30, but changed their story when we sent them a T4416 "for evaluation". Then a new rep called us, confirmed that there were in fact two separate V30 production lines and agreed to make us a special T Number OEM speaker. After a couple of months back and forth, we placed a large order and requested the special number assignment, at which time they cancelled the order and reneged on the deal. That's when we switched to Eminence. We haven't used Celestions speakers since.

It's not that V30s don't sound good with our amps. It's just that the T4416 sounds better. The T3904 is now made in China and after all these years, the P50E does what we wanted Celestion to do originally - and does it better, in fact - so we don't need Celestions help.

So, if you like V30s, there is nothing about the amp design that will be compromised using a V30. Our amps are not voiced "only" for the P50E. What is optimized for the P50E is the cabinet design. In that, the P50 will perform better in our cab than any others.

And now you know that when you say V30, you could be talking about 5 different speakers - that all sound slightly different:*

T3903 Standard 8 ohm
T3904 Standard 16 ohm
T3987 Marshall OEM 16 ohm
T4416 Mesa OEM 16 ohm
T4335 Mesa OEM 8 ohm

*When you change the impedance rating of the speaker, you also change the inductance of the coil which changes the resonant frequency among other things. So if you have 2 identical amps and 2 identical cabs - one cab loaded with 8 ohm speakers and amp set to 8 next to one loaded with 16 ohm speakers and amp set to 16, they will sound noticably different. The 16 ohm rig will usually sound brighter and deeper.

Personally I prefer the 4416, but not in a Recto 4X12. And therein lies the rabbit hole - you can't accurately compare like speakers in unlike cabs"
#821386
NippleWrestler wrote:"So if you have 2 identical amps and 2 identical cabs - one cab loaded with 8 ohm speakers and amp set to 8 next to one loaded with 16 ohm speakers and amp set to 16, they will sound noticably different. The 16 ohm rig will usually sound brighter and deeper."

Interesting. I've wondered about this. The other thing I wonder is what about an amp at 8 ohm into a 16 ohm speaker, ie. deliberate mismatch. Answers on the back of a postcard please...
#821394
Conway wrote:How different do they actually sound? I note the "H" heavy magnet adds 1.1kg to the weight!


One of my 2 favourite speakers include the Creamback H! I always think I like Greenbacks (Or Creamback M) but the soft attack and not very tight bass never suit my playing style. (Although apparently great in a closed back 4x12)
I’ve been through a few GBs and H speakers and my Favorire is the Creamback H 75!
Feel is more a contributor than the tone for me, I quite like the sound of a Greenback actually!